Practice makes perfect Fix the wire stripping machine with self-tapping screws and make sure to tighten the screws on the motor and stripped connectors with an M3 Allen Wrench. Choose the appropriate hole in the feeding panel based on the diameter of the wire.(Φ3.4, Φ5, Φ7, Φ10, Φ12, Φ17mm) After passing the wires through the hole, loosen the thumb screw to adjust the height of the feeding panel so that the wire is roughly parallel to the workbench, then tighten the screws. Use the regulating nut to adjust the distance between the blade and the shaft, so that the blade can cut the rubber layer outside the wire.The height of the blade may need to be adjusted several times to get the best cut. And tighten the screw nut with a spanner, Practice makes perfect. Connect the power supply, turn on the switch and turn the button to select the appropriate power to achieve automatic wire stripping. Practice makes perfect. (pay attention to the direction of blade rotation, first gear for stripping, second gear for retreating, shift to pay attention to the pause)